DIY: Faux Fur Printed Vest
So I realize it’s almost December and vest weather is long gone for some of you, but I live in sunny Southern California and it’s barely vest weather around these parts. This week I realized a printed faux fur vest was missing from my collection. Bring on the fabric, bring on the scissors, bring on the super easy DIY project…
Seriously, this is so easy! Do you guys remember the leather and fur trim vest I made for the Today Show? If not then click here for a refresher. This project is even easier because we’re skipping a step.
Start by making a run to your local fabric store and purchase a strip of faux fur fabric. Then, cut it to measure about half a yard in width by 1 yard in length. Your fabric should be shaped like a rectangle. You might need to adjust the measurements or trim the vest slightly to fit your body. Now, lay your fabric out completely flat and about 6 inches from the top, in the middle of the rectangle, cut two slips in the fabric for your arms about 12 inches apart. I used my sharpie marker to draw mark the spaces so I new exactly where my arm holes should go.
DIYers Note: Use painters tape to section off areas of your shoes before adding the glue and glitter.